Category: IDentifiers

Underneath you find the specsheets of our newest model IDentifier (V3) and our older model IDentifier (V2).

Specsheet IDentifierV3
Specsheet IDentifierV2

Note; the IDentifier V2 will no longer be available in our product range as of the 1st of  January 2021. Customers can keep using them on location, but we cannot replace them or send out additional ones.

After a while – a year or two in indoor environments – an IDentifier’s battery will eventually run dry. When this happens, replacing it is fairly simple. This page aims to teach you how to do so.

Object IDentifier

The process of replacing batteries is as follows, depending on the type of IDentifier you have;

V2 – IDentifier

1. Remove frontside using a fine flat screwdriver.
2. Carefully take out the PCB with transmitter and batteries.
3. Replace the 2 CR2032 lithium coin cells (batteries) off the transmitter.
4. Re-assemble the IDentifier.

Instruction-sheet Instruction IDentifierV2 Battery

V3 – IDentifier

1. Remove frontlabel using a fine small knife.
2. Remove the 4 screws with a T6-screwdriver
3. Remove the top cover whilst keeping the sealing in the front side.
4. Carefully take out the PCB with transmitter and batteries.
5. Replace the 2 CR2032 lithium coin cells (batteries) off the transmitter.
6. Re-assemble the IDentifier.

Instruction-sheet Instruction IDentifierV3 Battery_

Done!